Size: 4 1/8" x 5 3/8" (105mm x 137mm) The DL 137 is a two die set. They need to be die cut as if they were two separate dies. Place two stack craft paper strips, 1-1/2” wide, on the left side of the bottom plastic plate. Tape the die and paper together since you’ll be doing more than one die cut. Place one edge of the die/paper assembly over the shim set and die cut. No other shimming is needed. Turn the die and place an uncut edge over the shim set, die cut. Continue two more times until all four sides are die cut.